CPE510 Problem

CPE510 Problem

CPE510 Problem
CPE510 Problem
Saturday - last edited Monday
Model: CPE510  
Hardware Version: V3
Firmware Version: 2.2.4 Build 20230616 Rel. 32656 (0000)

I have 2 CPE510 one is the AP Source and other is the client, my problem is at exactly 5:48pm everyday to 6am my client has no internet connection. I already reset the 2 CPE but still same problem. Could you please help me.

  0      
  0      
#1
Options
1 Accepted Solution
Re:CPE510 Problem-Solution
Monday - last edited Monday

Hi  @ArielDivine 

 

Thanks for posting here.

This phenomenon is likely caused by interference from DFS channels.

 

What is DFS?

Dynamic Frequency Selection (DFS), refers to a mechanism to allow unlicensed devices, especially those operating out-door to share the 5GHz frequency bands which have been allocated to radar systems without causing interference to those radars.

 

How does DFS affect you?

The 5GHz device may choose a DFS channel during its initial state, so client device will not be able to find its wireless network for a while.

If the device is already operating on a DFS channel and radar signals are detected you will encounter disconnection, however the connection can be restored after a while. But you may see the change in the operating channel.

 

For more details,  you may refer to the following:

Brief introduction of DFS function

 

 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:CPE510 Problem-Solution
Monday - last edited Monday

Hi  @ArielDivine 

 

Thanks for posting here.

This phenomenon is likely caused by interference from DFS channels.

 

What is DFS?

Dynamic Frequency Selection (DFS), refers to a mechanism to allow unlicensed devices, especially those operating out-door to share the 5GHz frequency bands which have been allocated to radar systems without causing interference to those radars.

 

How does DFS affect you?

The 5GHz device may choose a DFS channel during its initial state, so client device will not be able to find its wireless network for a while.

If the device is already operating on a DFS channel and radar signals are detected you will encounter disconnection, however the connection can be restored after a while. But you may see the change in the operating channel.

 

For more details,  you may refer to the following:

Brief introduction of DFS function

 

 

Recommended Solution
  0  
  0  
#2
Options