MC200CM not working?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MC200CM not working?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MC200CM not working?
MC200CM not working?
2016-03-18 19:00:46 - last edited 2021-08-21 07:01:44
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

[SIZE=4]I have recently purchased an MC200CM. The setup is as follows: Router to cat5e cable to MC200CM 150 foot Multi-mode 62.5/125 cable to MC200CM to cat6 cable to router. The fiber cable was supposed to be in place of a regular copper cable. This setup doesn't seem to work, I get NO ​Internet connection. Please help![/SIZE]
  0      
  0      
#1
Options
7 Reply
Re:MC200CM not working?
2016-03-22 16:19:31 - last edited 2021-08-21 07:01:44
Have you tried to use Force Mode in both sides? And what is the LED status when they do not work?
  0  
  0  
#2
Options
Re:MC200CM not working?
2016-03-23 18:33:11 - last edited 2021-08-21 07:01:44
Yes, I have tried force more on both sides. No luck. All of the lights are green EXCEPT for the Rx light, it just blinks.
  0  
  0  
#3
Options
Re:MC200CM not working?
2016-03-28 18:40:52 - last edited 2021-08-21 07:01:44
oh, why not contact the supporter directly for help?
  0  
  0  
#4
Options
Re:MC200CM not working?
2016-04-01 12:26:04 - last edited 2021-08-21 07:01:44
And please take in mind the MC200CM is 1000Base-TX<-->1000Base-X, which means this converter can only work in Gigabit Network. Please check the Port speed of your routers.
  0  
  0  
#5
Options
Re:MC200CM not working?
2016-08-20 21:15:07 - last edited 2021-08-21 07:01:44
All of the lights are green EXCEPT for the Rx light, it just blinks.
  0  
  0  
#6
Options
MC200CM not working
2016-11-13 14:36:08 - last edited 2021-08-21 07:01:44
The dash lights are not operational, the fuel gauge and oil pressure work too.
  0  
  0  
#7
Options
MC200CM not working
2016-11-14 19:31:08 - last edited 2021-08-21 07:01:44
Shorting the wire to the sender to ground is the easiest way to identify a wiring issue. However, I very much doubt it is the IPVR since it also operates the fuel gage, so if it is working then it is not that. It could be a connection at the back of the cluster.
  0  
  0  
#8
Options

Information

Helpful: 0

Views: 1790

Replies: 7

Related Articles