Poor signal trength in TL-WA5210g

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Poor signal trength in TL-WA5210g

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Poor signal trength in TL-WA5210g
Poor signal trength in TL-WA5210g
2016-10-06 16:32:43
Model :

Hardware Version :

Firmware Version :

ISP :

Hi ,
I was configured Bridge mode(point to point in TL-WA5210. But i made sure the line of sight is o.k . whe i try to run timed ping to the device on the ther end. i get lots of 2 reply out of 15 and sometimes it shows destination hosts is unreachable. Need some some help on how to stabilize the signal
  0      
  0      
#1
Options
8 Reply
Re:Poor signal trength in TL-WA5210g
2016-10-07 01:49:49
and you think this is a Guessing Game
DISTANCE of the link
  0  
  0  
#2
Options
Re:Poor signal trength in TL-WA5210g
2016-10-07 16:27:29
distance between them is only 20m.
  0  
  0  
#3
Options
Re:Poor signal trength in TL-WA5210g
2016-10-07 16:46:11
In distance setting of the device the default value is set to 4km in both devices. May it be the reason for poor signal strength
  0  
  0  
#4
Options
Re:Poor signal trength in TL-WA5210g
2016-10-07 16:59:12
20 mts. is that the distance you need or that's a test
Distance is too close for 5210
Change value to indoor or change value to 0.22
  0  
  0  
#5
Options
Re:Poor signal trength in TL-WA5210g
2016-10-07 17:32:13
This is distance that i need.let me change the config and will share the update.
  0  
  0  
#6
Options
Re:Poor signal trength in TL-WA5210g
2016-10-07 18:26:27
Have changed the distance option to indoor. After pinging i receive destination host unreachable..!
  0  
  0  
#7
Options
Re:Poor signal trength in TL-WA5210g
2016-10-07 18:28:10
I have also tried adjusting Remote RSSI but still no luck.
  0  
  0  
#8
Options
Re:Poor signal trength in TL-WA5210g
2016-10-07 20:04:43
if you make a SITE SURVEY.... Can detect wireless signal of other devices far away..
you try set in other work mode to see problem in the bridge wds mode???

please, make your homework first when you obtain all necessary data, post results to try help you..

regards...
  0  
  0  
#9
Options