Internet <-> CPE210 ))) ((( CPE210 <-> Host ... Bridging problem. Paketloss 2%

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Internet <-> CPE210 ))) ((( CPE210 <-> Host ... Bridging problem. Paketloss 2%

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Internet <-> CPE210 ))) ((( CPE210 <-> Host ... Bridging problem. Paketloss 2%
Internet <-> CPE210 ))) ((( CPE210 <-> Host ... Bridging problem. Paketloss 2%
2017-01-02 16:20:22
Model :

Hardware Version :

Firmware Version :

ISP :

Hello guys,

i got the configuration here:

Internet <-> CPE210 ))) ((( CPE210 <-> Host

The CPE on the WAN side is the AP the other CPE on the host side is in set as bridge.

I got the problem that i got 2% paketloss on the WAN CPE side.
The CPE210 on the host side is without failures so far i could see with ifconfig.
In ifconfig i could see that the error counter is getting up and up.
The distance is 50M i got set both to 5 dbm power with MaxTream enabled and set to Auto.
There is a WPA2 configured and the link is up with 270 - 300 Mbit/s.
The link has 40 dbm SNR in both directions.
Im not sure what i could do to eliminate the 2% paketloss.
Its not my figure but with Ubiquiti there was 0,02% paketloss.

Any advises here ?

Regards,
Snot
  0      
  0      
#1
Options
1 Reply
Re:Internet <-> CPE210 ))) ((( CPE210 <-> Host ... Bridging problem. Paketloss 2%
2017-01-03 04:45:49
Further question: Why is the MTU of the MTU of the WLAN0 interface 2290 ?!
  0  
  0  
#2
Options