CPE210 Configuration
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Re:CPE210 Configuration
Menu Network->Switch. Add a VLAN, mark port to be used as untagged, make sure to set to Off for all other VLANs and tagged for CPU trunk, then click Save:
Next, go to menu Network->Interfaces, select the tab with your guest network's name and assign it to the VLAN interface created in the previous step. For VLAN 2, the interface name is eth0.2. Then click Save & Apply to activate both settings:
If the guest network is assigned a local SSID, the option " creates a bridge ..." may be ticked already. Then just add the port to the bridge assigned to this network (the radio boxes for interfaces will turn into selection boxes for multiple selections automatically).
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
Re:CPE210 Configuration
R1D2 wrote
Menu Network->Switch. Add a VLAN, mark port to be used as untagged, make sure to set to Off for all other VLANs and tagged for CPU trunk, then click Save:
Next, go to menu Network->Interfaces, select the tab with your guest network's name and assign it to the VLAN interface created in the previous step. For VLAN 2, the interface name is eth0.2. Then click Save & Apply to activate both settings:
If the guest network is assigned a local SSID, the option " creates a bridge ..." may be ticked already. Then just add the port to the bridge assigned to this network (the radio boxes for interfaces will turn into selection boxes for multiple selections automatically).
My firmware does not look like that nor does it have the Switch tab. That's why I thought I had to go into the files to activate the tabs.
Re:CPE210 Configuration
R1D2 wrote
Menu Network->Switch. Add a VLAN, mark port to be used as untagged, make sure to set to Off for all other VLANs and tagged for CPU trunk, then click Save:
Next, go to menu Network->Interfaces, select the tab with your guest network's name and assign it to the VLAN interface created in the previous step. For VLAN 2, the interface name is eth0.2. Then click Save & Apply to activate both settings:
If the guest network is assigned a local SSID, the option " creates a bridge ..." may be ticked already. Then just add the port to the bridge assigned to this network (the radio boxes for interfaces will turn into selection boxes for multiple selections automatically).
So, Finally able to get OpenWRT firmware looking how I think it should look. to get the Switch tabs had to run a script or two.
Configured it, but when I check the port's ip address, none show the ip address of the guest interface. I ran arp -a for the ip test. Almost there, i think, i hope.
See the attached screenshots::
.
Re:CPE210 Configuration
Well, I thought all was good until I hooked it up to the modem and all.Devices connect and obtain an IP Address , however, no internet access. Back to the drawing board.
Am able to get to the internet, however, once i try to associated the port 4 to the guest network things go south. see screenshots of the configuration before assigning the port 4 to vlan2.
You'll notice also that the site is not secure. Is because I havent set up firewall?
Am able to get to the internet, however, once i try to associated the port 4 to the guest network things go south. see screenshots of the configuration before assigning the port 4 to vlan2.
You'll notice also that the site is not secure. Is because I havent set up firewall?