Configuration Lan and troubleshooting CPE210
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configuration Lan and troubleshooting CPE210
Model :
Hardware Version :
Firmware Version :
ISP :
Hi, thanks for your attention.
I used a cpe 210 to connect my home to my lab that is located 30 mt from home.
I connected the Cpe210 to the home modem router (ISP) and in the lab I have a Tplink TL-WR841N router configured as WDS Bridging.
So far, it has always worked apart from the fact that every 10 days I have to restart the CPE because it unavoidably falls into the connection with the lab router.
For a couple of days, however, it does not work anymore.
Configuration:
Modem Router (ISP) Netis WF2411
IP 192.168.1.1
Subnet 255.255.255.0
Dhcp range 192.168.1.10
CPE 210 Acces Point Mode
IP Static 192.168.1.2
Subnet 255.255.255.0
Router TL-WR841N (Laboratory)
192.168.1.3
Subnet 255.255.255.0
Configured for WDS Bridging
Now a friend brought me a TP-Link TL-WA801ND Wireless Access Point that I do not use and I think I use this as a Client between the CPE 210 and the TL-WR841N Router.
You could kindly advise me on the correct configuration to create the network and avoid disconnections
Thank you ! Greetings
Hardware Version :
Firmware Version :
ISP :
Hi, thanks for your attention.
I used a cpe 210 to connect my home to my lab that is located 30 mt from home.
I connected the Cpe210 to the home modem router (ISP) and in the lab I have a Tplink TL-WR841N router configured as WDS Bridging.
So far, it has always worked apart from the fact that every 10 days I have to restart the CPE because it unavoidably falls into the connection with the lab router.
For a couple of days, however, it does not work anymore.
Configuration:
Modem Router (ISP) Netis WF2411
IP 192.168.1.1
Subnet 255.255.255.0
Dhcp range 192.168.1.10
CPE 210 Acces Point Mode
IP Static 192.168.1.2
Subnet 255.255.255.0
Router TL-WR841N (Laboratory)
192.168.1.3
Subnet 255.255.255.0
Configured for WDS Bridging
Now a friend brought me a TP-Link TL-WA801ND Wireless Access Point that I do not use and I think I use this as a Client between the CPE 210 and the TL-WR841N Router.
You could kindly advise me on the correct configuration to create the network and avoid disconnections
Thank you ! Greetings