TL-SG1016PE (Ver. 39357) shows "amount of VLAN is full"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

TL-SG1016PE (Ver. 39357) shows "amount of VLAN is full"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
15 Reply
Re:TL-SG1016PE (Ver. 39357) shows "amount of VLAN is full"
2017-09-01 15:29:13

Georg wrote

Hi, Hibixa -


I tried resetting and new configuration a few times in the past, with not effect.

I have re-installed the installed firmware (170530), powered the switch off and on, did a reset and - much to my surprise - I was able to define my VLAN settings.

Thanks for your feedback which gave me the drive to try it again.

That's great! ;) Glad to hear that.
  0  
  0  
#12
Options
Re:TL-SG1016PE (Ver. 39357) shows "amount of VLAN is full"
2018-03-21 17:53:08
I'm sorry, I'm new and I got too much of a place.
Someone could delete this text.
Thank you
  0  
  0  
#13
Options
TP-Link TL-SG1016PE Switch PoE
2018-03-21 17:54:22
I'm sorry, I'm new and I got too much of a place.
Someone could delete this text.
Thank you
  0  
  0  
#14
Options
Re:TL-SG1016PE (Ver. 39357) shows "amount of VLAN is full"
2018-05-25 11:41:12

SupportHelp wrote

I have the same problem.When I enter a VLAN I got the message: The amount of VLAN is full: The firmware of TL-SG1016DE 3.0 is 1.0.1 Build 20170530Any Idea!Thankshttp://supporthelp.com/quicken-support/
In the previous post, someone says that resetting the switch can solve the problem, maybe you can try.
  0  
  0  
#16
Options
Re:TL-SG1016PE (Ver. 39357) shows "amount of VLAN is full"
2018-05-26 00:19:10
For me, it took three or four reset before I could setup my VLANs. Reset does the trick, but it needs patience.
  0  
  0  
#17
Options