TL-SG108E Set Up
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG108E Set Up
Model :
Hardware Version :
Firmware Version :
ISP :
I've just bought a TL-SG108E Switch. From the label on the back of the switch it says V3.0
I can't access the config page.
There's nothing at 192.168.0.1 - it just times out.
The windows app states that "No Switch Appears in the Local Area Network"
IP scans don't show it.
It does not appear in my DCHP table.
I've tried turning firewalls off. Timed network access is disabled. The switch must be working because I can access stuff the LAN. Why can't I see the config panel?
I've got nothing on 192.168.0.x - everything on the LAN is 192.168.1.x
I've tried re-setting the switch (hard reset button on front).
How do I configure the switch?
Hardware Version :
Firmware Version :
ISP :
I've just bought a TL-SG108E Switch. From the label on the back of the switch it says V3.0
I can't access the config page.
There's nothing at 192.168.0.1 - it just times out.
The windows app states that "No Switch Appears in the Local Area Network"
IP scans don't show it.
It does not appear in my DCHP table.
I've tried turning firewalls off. Timed network access is disabled. The switch must be working because I can access stuff the LAN. Why can't I see the config panel?
I've got nothing on 192.168.0.x - everything on the LAN is 192.168.1.x
I've tried re-setting the switch (hard reset button on front).
How do I configure the switch?