EAP series products can either work under the control of the Omada Controller software or work independently as a standalone access point. This article shows you how to log in to its web interface on a standalone EAP.

 

Notes:

1. Old version of your web browser may cause compatibility problem with the web interface of EAPs. Please make sure the web browser is up to date.

2. The web interface of a specific EAP is not available once this EAP is adopted by the EAP Controller. Please close the EAP Controller software if any on your computer before trying to log into the web management page.

 

Typical scenario:

 

 

Step 1

Connect your computer to the EAP device with an Ethernet cable.

 

Step 2

Remember your computer’s current IP settings and manually assign a static IP address 192.168.0.100 for your computer.

For how to assign a static IP for your computer, please refer to this FAQ: How to configure TCP/IP Properties of my computer.

 

Step 3

Launch the web browser and enter the IP address 192.168.0.254. If you changed it before, you may need to do a hard reset on the EAP.

 

Step 4

Type in the username and password (both are admin in lower case by default) into the boxes of the login page and Login.

 

 

Step 5

Once you have finished configuring the EAP, revert your computer’s IP settings to what you have noted at the step 2.