In some scenarios, you need to set the corresponding VLAN on the EAP which is connected behind the switch, the network topology like Gateway---Switch-----EAP-Wall series product. If the VLAN settings on the front devices like VLAN 10, then you can also set the PVID (VLAN ID) for other ports on EAP as you want.
1. In controller mode, go to Devices, and click the desired EAP, then go to Config > Advanced in the Properties window.
2. Choose 2.4GHz or 5GHz, and select the corresponding ETH port to set the VLAN ID/PVID.

If you want to learn the detailed setup walkthrough, please click the direct link here.

Feedback:

We value your feedback on this FAQ, so any suggestions you have would be greatly appreciated! If you find an issue specific to this article, if any improvements can be made, or if you would like more details of settings, Let Us Know With a Comment.

Here are two methods for providing feedback:

• The option located in the bottom left corner of the linked FAQ (see below).

Click on Yes, you can open a Ticket if you have any suggestions.

Click on No, choose a reason, and put in your detailed feedback.

• The comment section at the bottom of this KB article (see below).

Note to provide as much detail as possible when submitting a request or feedback on an existing document including information regarding the section, area, or issue you had with the document and what could be improved.

We're looking forward to hearing from you soon!

*Note: This is to gather document feedback and content ideas only. If you are having a product concern, please find an appropriate thread or line of communication in the product forum accordingly.