@ralcubierre, start over, reset to defaults, with pin or from interface, last tab to the right, System at the bottom left when you set your log&pass select Test Mode as Region, in case you don't see...

clouca wrote keep this setup ?! just one thing you have to consider about your setup on B network, wired Clients are ok, but wireless Clients pay a 50% data penalty rate, Remember that you WILL lose...

@clouca, your wishes have been granted, but every coin has 2 sides, the scenario you have now, it's bettter than the one you want, with the new config. you might have exesive Broadcast, there are too...

Juan Mamani wrote don't see ssid in other devices Are the other devices 5Ghz as 7510 7510 is a point to point (PTP) device, of course you can set it as AP, but only 5 Ghz devices will see SSID

VSHome wrote The distance between root AP and TL-WA7210N is 10 feet this must be a typo error, please correct the 10 feet

rudi wrote bonding of LAN0 and LAN1 can improve the performance. I can only use Channel 100-140 if I select Germany Bonding, no idea. Have you tried, firmware 1.3.3 here...