rigid wrote Click Advanced > Load Balance > Policy Routing Protocol: All Protocols Source IP: (ie: 192.168.1.101-192.168.1.101) Destination IP: 0.0.0.0-0.0.0.0 (meaning all) WAN: (ie: WAN2) Click Add...

However i have issue setting up port forwarding for any network connected after the bridge. you want to do port forwarding for a local network? what's the network topology?

too many IP addresses :( , in this case, how about URL filter ??..

it's weird,. make sure the button you clicked is reboot but not restore?? if it's a firmware problem, all 600VPN users should meet this problem. anybody has same issue??

you can refer to this FAQ to configure VLAN, http://www.tp-link.com/en/article/?faqid=329 why the pictures are GARP ? i think no need to configure it.

if the router dead , i think no way to access and reboot it. maybe the traffic too heavy,, can you sperate the traffic of clients with another router? then check whether the problem will disappear..