@pman2022 Yes the CPE210 is set to static and by default has an IP address of 254. You don't have to but I would change the static on it to 250, 251, 253.. Reason being that 254 is a very common...

@pman2022 first thing that is evident is you do not have the gateway set in the CPE. Look in your routers DHCP settings and find the IP Range. It may be labeled as IP address range or pool. See image...

@pman2022 Not knowing how you have the CPE and AP set is a big drawback in figuring out the issue. Take a screen shot of your config and post here. For example this is my CPE connected in client mode...

@HackerJoe will do my best to answer. As far as distance, according to the CPE210 specs, that should work without issue. As for the CPE210 that you plan on putting at the remote end, which would be...

@mrjones1 not the answer you are looking for but.... bite the bullet and drill that hole. Reducing wireless connections whenever possible is always advantageous.

@pman2022 " I think what was happening is that when the two CPE210s are first booted up they work fine as APs until they find each other and depending on which one becomes the AP and which one...