@Andrew71 I see that AP is End of Life. I can't say for sure but it is possible the newer versions of the controller(s) do not support the device due to firmware. Not sure if they would release new...

@AVEDZ You mention you cannot even see or have extremely weak signal and that you are using a laptop for setup. Have you tried other wireless devices at that distance or just the laptop? Wi-fi...

@Madasafish This sounds like the characteristics of a stuck IR Cut Filter, which this camera does use. It should only be active in night vision mode. Try switching between day and night mode or...

@leobotes since you said "fully" I will share my experience. Out of 6 CPE710 I could not get a combination of any that resulted in them working "fully", meaning to specification. I tested all at a...

@Moinsen0815 I think an Omada compatible Gateway is required for this. Wait for other responses but I asked a similar question before and that is the answer I received.

@LeoCurrie TPllnk is notorious for convoluted firmware and hardware versions. Its likely you will never see that firmware version online and it may even be the same as the one you have. Just pretend...