It would be useful to have an "Enable/Disable" option for each Access Control Rule in the Firewall, just like it can be done in the Transmission->NAT tab. This is especially useful when exposing IPv6...

Hi, while i was playing around with the captive portal feature on the ER605, it has come to my attention that it only blocks IPv4 traffic, users can bypass the portal and gain access to the internet...

@borrrden this, along with NAT66 would be very helpful for people who have ISPs that only provide single addresses and only /64s subnets

hi, it would be nice to have a DHCPv6 "status page", allowing a sysadmin to look at active DHCPv6 leases and assign static addresses to the various devices, like the one that is currently available...

@Clive_A The problem is though, that the router does not allow me to block ICMPv6, When ICMP_ALL is selected in an ACL, only IPv4 can be chosen

@Clive_A It appears that the behavior has changed, i can no longer ping internal devices from outside, but i can still ping the ER605, only on IPv6 though. here's my setup: Server behind ER605: IPv4...