@forrest @TFTCM @RoRo7 @R1D2 Any idea on why TP-Link support is telling people to roll back to Build 20190404? From an email they sent me: "Please make sure that the firmware of your EAP is Build...

@R1D2 Thank you, again, for such a thorough explanation that a noob can understand. The ubiquiti forums were helpful in navigating their products and unique terminology, but less helpful in...

R1D2 wrote CoKro wrote 1. I'm using Firmware v: 1.0.1 Build 20131023 Rel.33236. Would that matter? 2. Should I change everything that was VLAN1 and create a VLAN10 to replace it across the board? 3....

R1D2 wrote @CoKro, Port 1 of the lower TL-SG1016DE switch must be a tagged member of VLAN 1, too. For the EAP, assign IoT SSID to VLAN 20 and another SSID to VLAN 1. As for management traffic of the...

Struggling to get the last piece of the puzzle into place. I recently bought an EAP225 to replace an old router being used as an access point. My goal was to set up a VLAN for my IoT devices separate...