This issue is also present on the TL-SG3428MPv1.0 with firmware 1.0.1. This issue is NOT present on the TL-SG3428v2.0 with firmware 2.0.3. I am also looking forward to working firmware.

I grabbed another switch and configured it to tag the traffic from the SG-2008P with the correct VLAN and put it between the controller and the SG-2008P. Once I did this the controller detected the...

@shberge The controller itself does not have a browser. I can tunnel through the router and access the switch from my laptop over http. I have tried both with and without the Controller IP entered in...

@Fae Thank you for your response. I have confirmed that Show Pending Devices is enabled. I believe I would not have been able to "see" the Access Points to adopt them otherwise. I have worked through...

I have a basic setup, with Omada Controller 4.3.5 running on an Ubuntu Server 20.04 machine and two EAP225 Access Points, all three of which are connected to an SG2008P switch. Switch IP is...

I am trying to do something I think should be possible based on my research so far but it isn't working correctly. I have an EAP245 connected to port 6 on a T1600G-28TS switch. I have the EAP245...