Setting up Gigabit switch - tl sg-1210p

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Setting up Gigabit switch - tl sg-1210p

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Setting up Gigabit switch - tl sg-1210p
Setting up Gigabit switch - tl sg-1210p
2020-06-16 03:37:14 - last edited 2020-06-18 03:33:26
Hardware Version: V1
Firmware Version:

I just pruchased, in error, an unmanaged switch, tl sg-1210p. Note there is no tl sg-1210p model to choose in the list.

 

Not sure how but it happened.

 

The reason for buying it was to set up a VLAN for SWMBO - I'm guessing I can no longer do that? It's P&P and near as I can see, no way to config it. The docs don't seem to have settings for it so I think it just picks up from DHCP?

 

Is there any way to prioritise traffic on this or do I need to upgrade?

  0      
  0      
#1
Options
1 Reply
Re:Setting up Gigabit switch - tl sg-1210p
2020-06-24 05:42:50

@Journeyman 

 

If you make sure that your switch is unmanaged switch, then of course it cannot set up VLAN. 

  0  
  0  
#2
Options