Team,

I'm using several switches of the model TL-SG2008P v1.0 and TL-SG2210P v3.20.

The SG2008P's have firmware level 1.0.9, and the SG2210P's have firmware 3.20.10.

On the SG2008P I have visibility on the active PoE ports and its remaining PoE power .

Which is not the case on the SG2210P - all ports are shown as regular Ethernet ports with a remaining PoE usage of 100%.

If I switch PoE off and on as a port profile override, the PoE visibility comes back.

But disappears after a while (keeping the connected PoE-device up-and-running!?).

If the PoE

Any suggestions how to keep this PoE power active?

With warm regards - Will