IP-Port Group cannot be applied in Switch ACL because its port count exceeds the ACL limit
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.IP-Port Group cannot be applied in Switch ACL because its port count exceeds the ACL limit
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm trying to figure out how come I can't seem to add a switch ACL rule.
I have 4 active ACL rules and when I try to turn on the 1st rule, I get the message - IP-Port Group cannot be applied in Switch ACL because its port count exceeds the ACL limit.
All firmware is up-to-date for every component.
The client setup is as follows:
Router - ER8411 v1.0
Controller - OC300 1.0 (with Controller Version 5.14.26.23)
Switch - TL-SG3210XHP-M2 v1.0
APs - EAP 683UR x 4 units
I have a similar ACL configuration at another site using OC200, ER605 and TL-SG2210MP and all 5 rules work and can be enabled on the switch.
Appreciate if anyone with a similar setup can assist me.
Much thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@GRL thank you for this!
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2195
Replies: 11
Voters 0
No one has voted for it yet.