Linking two switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Linking two switches

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Linking two switches
Linking two switches
2015-03-30 16:29:02
Region : Belgium

Model : TL-SG3424

Hardware Version :

Firmware Version :

ISP :


Hi,
I'm trying to link two switches ( A Sg3210 and a SG3424 ). Quite simple .... but Itn't working.
My configuration is : [Router] -- [Switch 3210] -- [Switch 3424] -- [Computes/printers/....]. On the Switch 3210 is also connected a Synology with 4 LAN's - with link agregation (test).
No VLAN,or other specific configuration.
Between the two switches, only one cable (tested). I have a second cable available ...if recommended, needed ...

So, what's wrong ? Any special settings needed ?
In advance, many thanks,
Marc
  0      
  0      
#1
Options
6 Reply
Re:Linking two switches
2015-03-30 17:16:12
Link Aggregation?
What have you done? Did you bind two network cards on your PC?
  1  
  1  
#2
Options
Re:Linking two switches
2015-03-30 18:40:50
A little more back
ground information would be nice.

Switch 1: TL-SG3210
Switch 2: TL-SG3424

How is your network layout?
For example: [Router] -- [Switch 1] -- [Switch 2] -- [Computer]?

How many cables are you putting between the switches? Just 1 or more?
Are both switches on basic settings?
No VLAN settings for example?
Are both switches powered on?
  1  
  1  
#3
Options
Additional Infos
2015-03-30 22:16:24
Hi,

My current configuration is : [Router] -- [Switch 3210] -- [Switch 2 3424] -- [Computers/printer/....]. On the 3210 is also connected to a Synology with 4 links (to test link Agregation - the synology has 4 LAN's) ...

Best Regards, and thank you !

M
  0  
  0  
#4
Options
Tests ...
2015-03-30 23:14:14
Hi,
I just made a small test with a piece of 0.5 cm UTP cable ... and it's working !
This morning, I have tested to orginal link cable ... loength of 25 m ... and good !
Any idea ?
Best Regards,
M
  0  
  0  
#5
Options
Re:Linking two switches
2015-03-31 13:53:30
Hi
After a careful examination of each element and reload the factory configuration of SG3210 ... I was very surprised that the link between the switches works!
Thank you for your suggestions,
To be closed
M
  0  
  0  
#6
Options
Sg2424
2015-06-26 03:29:50
Did some one configure this switch to use Link agregation for Synology Nas usage?

Regards

Isaac:confused:
  0  
  0  
#7
Options