TL-SG2210P VLAN setup.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Trying to setup a VLAN for some IP security cameras on my TL-SG2210P. I have the cameras in ports 1-4. Ports 5-8 are other network gear. 2 POE access points and an Unraid server. Data from router is hooked to SFP2. Can someone please help me? I can't figure out the proper VLAN settings.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, had similar issue.
Have a look at my thread in the same sub forum. New to VLANs
It might work for you too.
Regards, Graham
- Copy Link
- Report Inappropriate Content
It may be too late, but you make like to take a look at this FAQ.
It deals with almost everything (except ACL) that needs to be done for a switch like yours. I am not sure what kind of router you have, but in my case I did not have to worry about Step 1 for the router since my router handles multi-net NATing automatically.
- Copy Link
- Report Inappropriate Content
thanks. I'm out of town right now but will look into it when I get home.
I have an Arris TR4400 supplied by Spectrum.
- Copy Link
- Report Inappropriate Content
I'm not familiar with that router. However it is necessary that the router allows you to add routing rules mentioned in Step 2. I use an ASUS router with the ASUSWRT-Merlin firmware and Wi-Fi disabled. As you, I have two Wi-Fi APs connected to the switch.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1500
Replies: 4
Voters 0
No one has voted for it yet.