SOHO Switches
Hello all, My issue : Router TP-Link connected to port 1 of the switch to connect my network on internet. Port 5 : My Samsung TV to diffuse IPTV Port 6 : a raspberry PI running as a VPN In this config
Network Connectivity
By
Manu_Be
· Latest post 3 weeks ago
by Vincent-TP
0Helpful
169Views
I just bought an TL-SG105PE but I cannot get it to obtain an IP address and thus I cannot access the configuration interface. This seems to be due to a faulty implementation of the DHCP protocol. Upon
Network ConnectivityConfigurationFirmware UpdateDHCP
1Helpful
1094Views
We use the TP-Link SG1024DE in our networks and have identified a bug in the newer versions of the switch. When a IGMPv2 membership query is sent over the switch, if a IGMPv2 membership report is then
VLAN & Multi-NetworksNetwork ConnectivityIGMPv2
By
Peter_Immt
· Latest post 2026-03-12 03:46:04
by Hank21
0Helpful
813Views
My system has the following connected to the switch by Ethernet. EERO modem (port 1) synology NAS (LAN 1,2 bonded Port 2,3) - PC (port 4) tv (port 5). I want to set up link adregation. However, wehen
ConfigurationNetwork ConnectivityLAG
0Helpful
731Views
I purchased the TP-SG108E several years ago after setting up a Synology nas. Since than I've been using it as as unmanaged switch letting it do it's thing. Now I have added several more including a sm
ConfigurationNetwork ConnectivityFirmware Update
0Helpful
5029Views
I purchased a TPLink TL-SG1016PE switch new and used it to replace an unmanaged switch. Straight away it starts to show a LOT of errors, about 3x more errors than packets. It would only come up as 100
Network Connectivity
0Helpful
1995Views
Hi, Hope you're well. I have installed the TL-SG1005P in an off grid situation where the power supply can be spotty on occasion. I use starlink as my Internet provider. When there is a restart the dev
Network Connectivity
By
Inspiramus
· Latest post 2025-10-23 09:52:03
by Ethan-TP
0Helpful
463Views
Dear anyone, I'm at a loss, my switch had the port that is connected to the modum suddenly start blinking slowly. Both the green and amber light blink slowly and consistently. When I disconnect the ca
Network Connectivity
0Helpful
861Views
Hello, I'm a bit confused to configure network with VLAN, below is the scheme and settings I would like to make. I read that the same port cannot be untagged on multiple VLANs,but the configuration in
ConfigurationVLAN & Multi-NetworksNetwork Connectivity
2Helpful
1314Views
Network topology Fritz!Box 7590 Port 1 → TP‑Link TL‑SG105PE (connected to Deco X50, the mesh master) Port 2 → TP‑Link TL‑SG1016DE (connected to Deco M4 node) Symptom on TL‑SG1016DE At random intervals
Network Connectivityloop prevention
1Helpful
872Views
Purchased a used switch and when plugging in power I see the power light, but none of the status lights flash as the manual says they should and plugging in powered on devices and a router does not re
Network Connectivity
1Helpful
651Views
my setup MODEM <> ROUTER <> SG1218MP <> PC - We have around 600Mbps internet BW. - router is connected to port 17 - my pc is connected to one of available lan ports and when performing speed test. i o
Network Connectivity
1Helpful
733Views