Gateways
I have wireguard configured on the gateway acting as a VPN server. The "Local IP Address" on the gateway's wireguard config (10.16.16.1) is set to a subnet unused by any of the existing VLANs. There i
VPNRoutingWireGuard
1Helpful
217Views
Evening, I setup a VPN server (OpenVPN), which worked fine until the classical problem of an ISP changing the public IP got revealed. Since the router has support for dynamic DNS, I created a domain a
DDNSVPNWireGuardACL
0Helpful
156Views
I configured a Wireguard VPN between two ER605 site-to-site devices, but I realized, or at least couldn't find, a way to choose a default route for the ER605 from the branch office to connect to the m
VPNWAN SetupRoutingWireGuard
By
fabio_brandao1
· Latest post a week ago
by NeilR_M
0Helpful
192Views
Hi, I need to route the entire traffic from a few clients through a wireguard tunnel. I asked 2023 for that feature and implementation was planned for Q1 2024. Can someone confirm that it is possible
VPNACLRoutingWireGuard
0Helpful
260Views
Hi. I'm trying to configure the gateway ER605 as VPN Server using Wireguard profile. I describe the scenery: Local network: 192.168.1.0 Router local IP: 192.168.1.1 Mode: PPPoe (Movistar router on bri
VPNWireGuard
0Helpful
381Views
Hello, I’m experiencing a recurring connectivity issue that occurs approximately once per month when my ISP modems receive new IP addresses. Setup Description: I’m operating two different configuratio
WireGuardControllerRoutingVPNModem
By
olli_foxtech
· Latest post 2026-01-26 08:49:04
by Hank21
0Helpful
183Views
Hi, I'm quite new to Omada setups. I have: * multiple subnets * WireGuard access * configured "LAN DNS" in order to achive split DNS Everything is working fine. When I'm in one of the configured subne
WireGuardDNS
0Helpful
255Views
My cabin is running some network with solar panel and battery. In darker day of winter I must shut down the power when i'm off site to save the battery. Last winter, everytime I power up the system, e
ControllerFirmware UpdateWireGuardNetwork Connectivity
By
Firemen027
· Latest post 2026-01-07 14:35:59
by Firemen027
1Helpful
547Views
Problem Description: I’m using TP-Link Omada Controller v5.15.24.19 with an ER7206 VPN Router. I have a WireGuard server running on CasaOS in Germany. My goal is to route messaging applications (e.g.,
WireGuardRoutingVPNWAN Setup
1Helpful
602Views
Just looking to see if there is a new expected version release that will have this requested feature? it says that it was expected in version "ETA V5.16.X adapted firmware and controller" but we seem
VPNRoutingWireGuard
0Helpful
739Views
Hello I have setup the Wireguard I have set this up using the guide https://community.tp-link.com/en/business/forum/topic/619652 But after I have activate the tunnel whick works fine I tried to ping t
VPNWireGuard
6Helpful
1169Views
The hardware version is 2.20. When I connect to Wireguard with Full Traffic enabled, I don't have internet access or access to the remote local network. When I connect with Full Traffic disabled, I ca
VPNWireGuardNetwork Connectivity
0Helpful
485Views