Unable to Adopt EAP110-Outdoor
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to Adopt EAP110-Outdoor
Model :
Hardware Version :
Firmware Version :
ISP :
I cannot adopt via the EAP Discovery Utility or EAP Controller no matter what I try.
With the Discovery Utility when I try to configure it I get a "Setting Failed" message after 10-15 seconds
With the Controller it just spins and spins until I refresh it. When I do refresh it has an error that says "User name or password is wrong"
All was working for the past few weeks until the PoE power supply died. I replaced the PoE power supply but cannot get the network back up. I have done just about everything I can think of to include every recommendation I've found in these forums.
I would sure appreciate any help on what I might be over looking. The most frustrating part is that I changed nothing from when all was working fine before the PoE failure. I even bought a second (new) EAP110 thinking the one I had went bad with the PoE.
Please help
Hardware Version :
Firmware Version :
ISP :
I cannot adopt via the EAP Discovery Utility or EAP Controller no matter what I try.
With the Discovery Utility when I try to configure it I get a "Setting Failed" message after 10-15 seconds
With the Controller it just spins and spins until I refresh it. When I do refresh it has an error that says "User name or password is wrong"
All was working for the past few weeks until the PoE power supply died. I replaced the PoE power supply but cannot get the network back up. I have done just about everything I can think of to include every recommendation I've found in these forums.
I would sure appreciate any help on what I might be over looking. The most frustrating part is that I changed nothing from when all was working fine before the PoE failure. I even bought a second (new) EAP110 thinking the one I had went bad with the PoE.
Please help
