Dual WAN configuration TL-R480T
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dual WAN configuration TL-R480T
Model :
Hardware Version :
Firmware Version :
ISP :
Hello everyone, I am new to the forum but I always follow you so I know you can be of help..
I know that there is the faq 530 that is a valid help in this configuration but not for the mine.
I have a network divided into two offices of a company.
these networks have ip 192.168.2.x and 192.168.3.x
The host on the 192.168.3.x network went online through the other subnet without a standalone DSL contract.
Now, another separate contract on the 192.168.3.x network has been activated
I want that the users go to the internet through the new applet and to the other hosts through the older network.
This is the configuration that i apply to my TL-R480T.
WAN 1 192.168.3.100
Sub 255.255.255.0
Gatway 192.168.3.200 -> old router address
DNS 192.168.2.250 -> DNS site master
WAN2 192.168.3.101
Sub 255.255.255.0
Gatway 192.168.3.1 -> new dsl connection address
DNS 192.168.3.1
The two wan's addressing i hope that are correct.
The problem arises with the LAN address of the dual wan router. If i put the address 192.168.3.x, the answer is that the LAN and the WAN cannot stay on the same subnet.
If I put it in 192.168.x.x I can not reach it from hosts on the network.
Hardware Version :
Firmware Version :
ISP :
Hello everyone, I am new to the forum but I always follow you so I know you can be of help..
I know that there is the faq 530 that is a valid help in this configuration but not for the mine.
I have a network divided into two offices of a company.
these networks have ip 192.168.2.x and 192.168.3.x
The host on the 192.168.3.x network went online through the other subnet without a standalone DSL contract.
Now, another separate contract on the 192.168.3.x network has been activated
I want that the users go to the internet through the new applet and to the other hosts through the older network.
This is the configuration that i apply to my TL-R480T.
WAN 1 192.168.3.100
Sub 255.255.255.0
Gatway 192.168.3.200 -> old router address
DNS 192.168.2.250 -> DNS site master
WAN2 192.168.3.101
Sub 255.255.255.0
Gatway 192.168.3.1 -> new dsl connection address
DNS 192.168.3.1
The two wan's addressing i hope that are correct.
The problem arises with the LAN address of the dual wan router. If i put the address 192.168.3.x, the answer is that the LAN and the WAN cannot stay on the same subnet.
If I put it in 192.168.x.x I can not reach it from hosts on the network.