ER6120 Static Routes don't work
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER6120 Static Routes don't work
Model :
Hardware Version :
Firmware Version :
ISP :
Hello there,
we have 2 ER6120 routers, setup with few static routes that are not working.
Both routeurs can "ping" external routes via the diagnostics intercaface, but all equipements plug to the LAN can not ping external routes.
Static routes are "routed" by 2 Openvpn Linux servers and works well. If we setup these servers as default gateway, all routes works.
We have two other ER6120 routers in V1 mode, and they worked perfectly. Only the V2 don't.
Is there an addtionnal config to make on the V2 routers to active static routes ?
Below screen shots of the configuration and tests:
Thanks for your idea or advices.
Best regards,
Vincent
Hardware Version :
Firmware Version :
ISP :
Hello there,
we have 2 ER6120 routers, setup with few static routes that are not working.
Both routeurs can "ping" external routes via the diagnostics intercaface, but all equipements plug to the LAN can not ping external routes.
Static routes are "routed" by 2 Openvpn Linux servers and works well. If we setup these servers as default gateway, all routes works.
We have two other ER6120 routers in V1 mode, and they worked perfectly. Only the V2 don't.
Is there an addtionnal config to make on the V2 routers to active static routes ?
Below screen shots of the configuration and tests:
Thanks for your idea or advices.
Best regards,
Vincent
