Bug tl-er604w - the route created by vpn not deleted automatic
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bug tl-er604w - the route created by vpn not deleted automatic
Model :
TL-ER604W
Hardware Version : TL-ER604W v2.0
Firmware Version : 1.2.0 Build 20160825 Rel.45880s
ISP :
My scenario, I have two sites (point A and point B) and I need to connect both.
I have two links to connect this sites, first link is a mpls (point to point, I dont have internet) and secondy link is a VPN through internet. They work using FailOver. The VPN is not active, only will active if mpls is down.
I have configured router in "mode classic":
- enable two WAN (WAN1 mpls and WAN2 internet)
- enable failover (primary Wan1 and backup Wan2)
- create static route to point B access network in point A by mpls
- create access rule allow point A to access LAN in point B
- create VPN IKE IPsec Site-to-Site by Wan2
- configure online detection to Wan1 verify if mpls is online.
This scenario is perfect and mpls is online and Wan2 is down. When I turnoff mpls, Wan1 disable, Wan2 enable, VPN connect, it creates automatic route to access point A and work like a charm. When mpls return there is the problem: VPN disconnect, Wan2 is down, Wan1 is online, ok, but the route was created by vpn is not deleted. So, the mpls route not works.
This route need to be deleted, interface Wan2 is down, I cannot have any route to Wan2. This may be a bug. Could you help us?
Hardware Version : TL-ER604W v2.0
Firmware Version : 1.2.0 Build 20160825 Rel.45880s
ISP :
My scenario, I have two sites (point A and point B) and I need to connect both.
I have two links to connect this sites, first link is a mpls (point to point, I dont have internet) and secondy link is a VPN through internet. They work using FailOver. The VPN is not active, only will active if mpls is down.
I have configured router in "mode classic":
- enable two WAN (WAN1 mpls and WAN2 internet)
- enable failover (primary Wan1 and backup Wan2)
- create static route to point B access network in point A by mpls
- create access rule allow point A to access LAN in point B
- create VPN IKE IPsec Site-to-Site by Wan2
- configure online detection to Wan1 verify if mpls is online.
This scenario is perfect and mpls is online and Wan2 is down. When I turnoff mpls, Wan1 disable, Wan2 enable, VPN connect, it creates automatic route to access point A and work like a charm. When mpls return there is the problem: VPN disconnect, Wan2 is down, Wan1 is online, ok, but the route was created by vpn is not deleted. So, the mpls route not works.
This route need to be deleted, interface Wan2 is down, I cannot have any route to Wan2. This may be a bug. Could you help us?
Re:Bug tl-er604w - the route created by vpn not deleted automatic
I agree with you, follow the attached screenshot. In this case, the route was deleted because I click in inactive, but, if failover is enable and primary link return automatic, the vpn will down and not delete route entry.
Images a and b => vpn connect in WAN2 and route entry created
a)
b)
Images c and d => vpn disconnect and route entry deleted
c)
d)
Thanks
Images a and b => vpn connect in WAN2 and route entry created
a)
b)
Images c and d => vpn disconnect and route entry deleted
c)
d)
Thanks