TL-R600VPN VPN connects but unable to establish RDP or http sessions
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R600VPN VPN connects but unable to establish RDP or http sessions
Model :
Hardware Version :
Firmware Version :
ISP :
I have just purchased and setup a TL-R600VPN router, Hardware version 4 and Firmware Version 4.0.1 Build 20171128 Rel.60595
I have created a Client-to-Lan IPSEC/IKE VPN, and I can connect to the TL-R600VPN using either Netgear VPN client software or the Shrew Soft VPN client.
Once connected, from the client I can ping my server on the Lan side of the VPN connection.
However, I cannot connect via RDP or via a web browser ( port 80 ) connection to the same server.
The RDP session will prompt me for a username/password, which I enter, and then will display a completely black RDP screen before failing with "An internal error has occurred"
The web browser fails with a "Can't reach this page" error.
On perhaps 1 in 100 attempts it will successfully connect via RDP or the web browser, but if you log out and then try to reconnect it will fail.
Note: if I create a port forward for TCP port 80 ( browser ) or TCP port 3389 ( RDP ) in the TL-R600VPN, then I can connect every time using RDP or a Web browser.
This would imply the server on the Lan side of the TL-R600 is configured an operating correctly.
The problem must be with the TL-R600VPN.
Any ideas or suggestions ?
Regards
Andrew
Hardware Version :
Firmware Version :
ISP :
I have just purchased and setup a TL-R600VPN router, Hardware version 4 and Firmware Version 4.0.1 Build 20171128 Rel.60595
I have created a Client-to-Lan IPSEC/IKE VPN, and I can connect to the TL-R600VPN using either Netgear VPN client software or the Shrew Soft VPN client.
Once connected, from the client I can ping my server on the Lan side of the VPN connection.
However, I cannot connect via RDP or via a web browser ( port 80 ) connection to the same server.
The RDP session will prompt me for a username/password, which I enter, and then will display a completely black RDP screen before failing with "An internal error has occurred"
The web browser fails with a "Can't reach this page" error.
On perhaps 1 in 100 attempts it will successfully connect via RDP or the web browser, but if you log out and then try to reconnect it will fail.
Note: if I create a port forward for TCP port 80 ( browser ) or TCP port 3389 ( RDP ) in the TL-R600VPN, then I can connect every time using RDP or a Web browser.
This would imply the server on the Lan side of the TL-R600 is configured an operating correctly.
The problem must be with the TL-R600VPN.
Any ideas or suggestions ?
Regards
Andrew
