CPE220 V2 Safeloader Password and firmware Recovery process
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.CPE220 V2 Safeloader Password and firmware Recovery process
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
What is the password for the Safeloader Menu for the CPE220 V2 and what is the process to recover it using a Serial Cable?
This is assuming the device has been flashed with Openwrt or DD-WRT or a similar firmware.
I do not have one but have been asked the process.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
We managed to recover the device.
I compiled a RAM Version of the software which we renamed to vmlinux and it booted right up.
We were then able to use scp to upload a full version of the software and use sysupgrade -F -v -n /tmp/filename.bin to reflash it.
The Source code I used is located here https://github.com/robimarko/source/tree/CPE220-v2
- Copy Link
- Report Inappropriate Content
Great work, apcameron! 
- Copy Link
- Report Inappropriate Content
Hello, I wrote you a private message. Someone who can pass me the vmlinuz by private message? I tried to compile the source code but I couldn't, it gave me an error, and without that vmlinuz I can't recover my cpe 220 v2
- Copy Link
- Report Inappropriate Content
@apcameron i have the same problem i need vmlinuz file
- Copy Link
- Report Inappropriate Content
Dear @tekniking,
You may refer to the following FAQ to do the firmware recovery.
How to use firmware recovery on the Pharos products, https://www.tp-link.com/support/faq/2954/
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 8866
Replies: 15
Voters 0
No one has voted for it yet.