EAP225 avop en is awy

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP225 avop en is awy

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225 avop en is awy
EAP225 avop en is awy
2018-10-31 08:57:17

 

Hey,

 

I have an EAP 225 that I configured via the web interface. However, I also want to manage these remotely via the cloud function. I have therefore used the controller software, only if I click on avop, the EAP is no longer visible and the WIFI connection is gone. Than i have te reset the EAP en begin with a new installation.  What is the best method in this? I want to manage and monitor this remotely?

 

Thanks,

 

Mark

  0      
  0      
#1
Options
4 Reply
Re:EAP225 avop en is awy
2018-11-01 06:56:49

1. You should bind the Omada Controller with the TP-Link ID first.

2. Log in to the cloud platform (omada.tplinkcloud.com) with corresponding TP-Link ID (Or use Omada APP). Then we can access the management page of Omada Controller in the cloud, monitor and manage Controller/EAP in real time.

 

You can refer to: https://community.tp-link.com/en/business/forum/topic/150541?page=1 and https://community.tp-link.com/en/business/forum/topic/150133?page=1

 

  0  
  0  
#2
Options
Re:Re:EAP225 avop en is awy
2018-11-01 18:41:57

Dear Jonas,

 

Yhank you for the answer. I think some is going wrong. In the controller i can not see the EAP. 

Now i have acces with the mobile app to my controller, bur there is the EAP 225 not to see.

How can i connect the EAP (who i have installed via the webinterface) in the controller?

 

Mark

  0  
  0  
#3
Options
Re:Re:Re:EAP225 avop en is awy
2018-11-02 01:44:48

I think the problem is that your Controller did not manage EAP, so you can't see the EAP on the cloud via Omada Controller.

 

If the EAP and Controller locate in same subnet, you can see it in the pending list of Controller, then you can adopt it directly. If the EAP and Controller locate in different subnet, you should use Discovery Utility or DHCP Option 138 to tell the IP address of Controller to EAP first, then EAP will show up in the pending list of Contorller. You can refer to this Configuration guide: https://www.tp-link.com/en/configuration-guides/configuration_guide_for_managing_eaps_via_eap_controller/?configurationId=2969

  0  
  0  
#4
Options
Re:Re:Re:EAP225 avop en is awy
2018-11-03 16:49:55
Hi Mark, you may tell us about your topology first. Where do you place your EAP and controller? Are they in the same subnet or different subnet?
  0  
  0  
#5
Options