TL-R480t+ shows wan1 status disconnected, and wan2 connected. Both connections are working fine

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R480t+ shows wan1 status disconnected, and wan2 connected. Both connections are working fine
TL-R480t+ shows wan1 status disconnected, and wan2 connected. Both connections are working fine
2019-09-26 01:17:58 - last edited 2021-08-21 06:40:48
Model: TL-R480T+  
Hardware Version: V7
Firmware Version: v9

Hi to everyone.

 

I have a TL-R480T+ smb load balance broadband router.

I've configured 2 wan connections.  

The first is a Telmex Modem with the IP Address 192.168.10.254

The second is a TotalPlay Modem with IP Address 123.10.10.1

 

Yesterday I configured this device, and both connections are working on system Status.

Today, I see my web interface and the first connection is Not Connected.

Also, if I connect the Telmex connection to a computer, the internet service is currently working.

The second connection always shows Status Connected.

 

The Link Backup is configured: 

ID Primary WAN Backup WAN Mode Effective Time Status Operation
  1 WAN1 WAN2 Failover -- Enabled  

 

This is the Wan Status List

WAN Status List

ID Port Port Status Operation
1 WAN1 Offline  
2 WAN2 Online  
3 WAN3 Offline  
4 WAN4 Offline  

 

 

What's hapenning with my broadband router?

can anyone tell me about this situation?

 

 

  0      
  0      
#1
Options