VPN tunnel does not route packeages

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

VPN tunnel does not route packeages

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VPN tunnel does not route packeages
VPN tunnel does not route packeages
2019-10-19 00:12:07 - last edited 2021-04-19 11:49:25

Hello everyone,,,

Model: TL-ER6020

Hardware Version: V1

Firmware Version: 1.1.0 Build 20150416 Rel.35252

I have two tunnels sitte-to-site, has gateway TL-ER6020 in each remote location TL-R600VPN,  one tunnel works fine, but the other only sees or ping the TL-R600VPN rotuer ip, they are exactly the same, I have change ike policy and ipsec proposal and the tunnel still up, but only ping the router, I did uncjheck 

 Block Ping Packet From WAN Port

 Block Ping Packet From LAN Port

 

 

1.- does any body know why?

2.- can my router vin check  TL-ER6020 only sopports one ipsec tunnel?

 

any comments are welcome at this point.

 

Thank you

  0      
  0      
#1
Options
1 Reply
Re:VPN tunnel does not route packeages
2019-10-21 02:24:57 - last edited 2021-04-19 11:49:25

@Pennywoloz 

 

ER6020 supports multiple IPsec VPN. 

What proposal did you used? Try to use ESP for phase-2.

Did you ever export the configuration from one R600VPN to the other one R600VPN? If yes, try to reset the router and re-configure manually.

 

 

  0  
  0  
#2
Options