Blank web page
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a T1600G-28TS. It's 2 years and working fine, but now I need to make some changes and I've found that the web page is innaccessible.
When I input its IP in the address bar of the browser (Firefox, Chrome, Edge, IE11 tested), all I get is a blank page.
Both the IP address and the cable connection are correct.
I do not know what else to do.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
You should make sure what IP your switch is using. Then check if you can ping the IP address. Then try to telnet the switch. If you can telnet, still can configure the switch through CLI command at least.
About the blank page, maybe you can change another PC or disable antivirus software temporarily for testing.
- Copy Link
- Report Inappropriate Content
If you can telnet your switch, also check, if you disabled your HTTP/HTTPS sessions "no ip http session / no ip http secure-session"
- Copy Link
- Report Inappropriate Content
I've been off for weeks, so it's been impossible for me to test the things you say.
I've checked the IP, and it's ok. I can also access via telnet.
I've even reset to factory defaults and when I launch the browser and type the IP of the swith, I keeping getting a blank page as a result.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Andone This command does not exit, at least in this model, but I have tried the command no ip http server. After running it, the browser can't stablish connection with the switch. Then, after running ip http server command, can connect but a simple blank page is the result.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1569
Replies: 6
Voters 0
No one has voted for it yet.