External Web Portal w/ Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

External Web Portal w/ Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
External Web Portal w/ Controller
External Web Portal w/ Controller
2019-11-04 13:55:02 - last edited 2019-11-05 02:40:30
Model: EAP245  
Hardware Version: V3
Firmware Version: 2.2.0 Build 20190530 Rel. 56122

Hi,

 

  I'm trying to configure an external portal on my Controller Omada, each one of the steps in this article below is working, except the step 10.

 

    Article: Source code template for External Web Portal (Controller 3.0.5 or below)

    https://www.tp-link.com/br/support/faq/916/

 

    Other appliance

    Controller Model: OC200 1.0

    Firmware Version: 1.2.0 Build 20190823 Rel.42002

    Controller Version: 3.2.3

 

    At this page is defining the credentials to authenticate on my Server Radius.

 

     But after submitting is redirect to this page below on my Omada, being the URL http://IP-LAN-FROM-OMADA/portal/auth

 

 

    Is it normal or did i made any mistake?

 

    Thanks a lot.

  0      
  0      
#1
Options
4 Reply
Re:External Web Portal w/ Controller
2019-11-06 12:10:01

 

Similar thing happens when I use the article for the versions above.


Source code template for External Web Portal (Controller 3.1.4 or above)
https://www.tp-link.com/br/support/faq/2390/

 

 

 

  0  
  0  
#2
Options
Re:External Web Portal w/ Controller
2020-04-21 19:20:27
It looks like you are using the wrong url... For the Omada Controller you want to use target_url:target_port/radius/portal/auth
Working at Stampede, trying to rid the world of poor captive portals https://stampede.ai
  0  
  0  
#3
Options
Re:External Web Portal w/ Controller
2020-08-02 14:34:57

 

The same is here that suddenly happens when I use the article for the previous versions.

 

 

 

  0  
  0  
#4
Options
Re:External Web Portal w/ Controller
2020-08-03 12:12:57

@AmbarSaria 

That happens because of the special character in the SSID, like #,@,$

 

  0  
  0  
#5
Options