EAP 225 outdoor brick in during firmware update
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Eap 225 outdoor is disconnected from oc200 controller ,when firmware upgrade to 1.7.0 Build 2020113 Ref. 35383. Led blink green ,red,yellow all time and lan port not working.Please how can i recovery firmware?.Reset button not woking.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
If the EAP powers off when it is upgrading a new firmware, this EAP device will be bricked. In this situation, you can contact your retailer to ask for an RMA.
Please check if the EAP can still obtain IP address from the DHCP server, normally if the EAP is bricked, it will be 192.168.0.254 and will not obtain any IP from the DHCP server.
- Copy Link
- Report Inappropriate Content
Lan port does not work. Reset button not ok. I think Eap connect with only serial port.
- Copy Link
- Report Inappropriate Content
@jummer79 hi i have the same problem. reset button does not work and it only blinks ( green-orange-green ).
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I'm in a similar situation, without warranty but not bricked, want to restore a firmware original, no official solution yet, zero support.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3091
Replies: 5
Voters 0
No one has voted for it yet.