ER6020 Balancing configuration with policies and backup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER6020 Balancing configuration with policies and backup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER6020 Balancing configuration with policies and backup
ER6020 Balancing configuration with policies and backup
2020-04-29 17:02:55 - last edited 2021-04-19 11:16:05
Model: TL-ER6020  
Hardware Version: V2
Firmware Version: 2.0.2 Build 20180702 Rel.59031

I have installed a TL-ER6020 with two WAN lines, one fiber and one 4G for backup. (WAN1, WAN2)

Now I need to install another fiber WAN line (WAN3) and I would like to make a group of IP`s on the LAN go out to the Internet on WAN1 and another group of IP`s on WAN3.

For Backup I would like to leave WAN3 in case WAN1 falls, and on the contrary, if WAN3 falls use WAN1.

I would leave WAN2 for backup in the event that the two fibers fall (WAN1, WAN3)

I would appreciate if someone could help me in such configuration.

 

Thank you.

  0      
  0      
#1
Options
1 Reply
Re:ER6020 Balancing configuration with policies and backup
2020-04-30 08:34:26 - last edited 2021-04-19 11:16:05

@MEYRA_SOFTWARE 

 

Now I need to install another fiber WAN line (WAN3) and I would like to make a group of IP`s on the LAN go out to the Internet on WAN1 and another group of IP`s on WAN3.

 

You can use Policy routing to achieve the demand. 

https://www.tp-link.com/en/support/faq/2134/

 

 

For Backup I would like to leave WAN3 in case WAN1 falls, and on the contrary, if WAN3 falls use WAN1.

I would leave WAN2 for backup in the event that the two fibers fall (WAN1, WAN3)

 

You just need to set link backup, WAN1 and WAN3 is primary WAN, WAN2 is backup WAN. 

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 488

Replies: 1