Monitor Client Roaming activity.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Monitor Client Roaming activity.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Monitor Client Roaming activity.
Monitor Client Roaming activity.
2020-04-30 14:44:19
Model: EAP225  
Hardware Version:
Firmware Version:

Hi,

 

I've got at home a setup with 2EAP 225, 1EAP235 and 1 EAP outdoor. Omada is installed on a Rpi3

 

My wife and my kids are rporting disconnection even if they are not moving within the House.

 

I suspect that they are roaming from one AP to another one or to the 5ghz band that might cause these disconnect.

 

Is there a way to track or graph these movement between AP ?

 

 

  0      
  0      
#1
Options
3 Reply
Re:Monitor Client Roaming activity.
2020-04-30 19:29:27

 

Ced2ric wrote

I suspect that they are roaming from one AP to another one or to the 5ghz band that might cause these disconnect.

 

Could be, but then this means that you have just too much EAPs on a too small area, so their WiFi cells are overlapping.

How big is your house (length × width)?

 

Is there a way to track or graph these movement between AP ?

 

 

No, there is no such function in Omada controller as far as I know.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:Monitor Client Roaming activity.
2020-05-02 10:33:05

@R1D2 

 

Hi house has 15m large and 10 m depth per floor. 2 floor and an atic.

 

Each antenna's are using a separate channel on both the 2.4 and the 5ghz spectrum.

 

 

  0  
  0  
#3
Options
Re:Monitor Client Roaming activity.
2020-05-02 15:35:22 - last edited 2020-05-02 15:35:49

 

Ced2ric wrote

Hi house has 15m large and 10 m depth per floor. 2 floor and an atic.

 

Each antenna's are using a separate channel on both the 2.4 and the 5ghz spectrum.

 

In my opinion it's overkill to use 4 EAPs on such a small area, except your walls and ceilings are made out of reinforced concrete (ferroconcrete). If you use a common SSID on all 4 EAPs, try to reduce Tx power to avoid disconnects caused by (basic) roaming. 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options