3 x CPE210 as point to multipoint: help for configuration neede

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

3 x CPE210 as point to multipoint: help for configuration neede

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
3 x CPE210 as point to multipoint: help for configuration neede
3 x CPE210 as point to multipoint: help for configuration neede
2020-05-05 15:01:36 - last edited 2020-06-06 10:09:31
Model: CPE210  
Hardware Version: V3
Firmware Version: current

Hi,

 

I have a working bridge of 2 CPE210 units that work perfectly.
I need to set up another CPE210  and thereby make it a multipoint-system.

 

There's a how to from 2016 where it's stated that you have to put in the MAC adresses and that only WEP is supported:
https://www.tp-link.com/no/support/faq/178/

 

And then there is the manual, where it seems quite easy, but the config doesn't work:

https://www.manualslib.com/manual/865692/Tp-Link-Cpe210.html?page=16#manual

 

Can you give me any recommendation on how to get this working?

 

Thank you very much!

 

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 518

Replies: 0