Interface configuration on R480T+

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Interface configuration on R480T+

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Interface configuration on R480T+
Interface configuration on R480T+
2020-05-06 19:05:15 - last edited 2021-04-19 11:15:31
Model: TL-R480T+  
Hardware Version: V9
Firmware Version: 9.0.2

Hi there,

 

Is it possible to configure R480T+, any of the interfaces as WAN and LAN using 802.11q. Please, have a look on the scheme:

 

 

 

The VLAN config is OK, I have connectivity in vlan20 and vlan1, but R480T+ GUI does not allow to set WAN interface in the vlan10.

 

Any help will be much appreciated!

  0      
  0      
#1
Options
1 Accepted Solution
Re:Interface configuration on R480T+-Solution
2020-05-07 02:40:43 - last edited 2021-04-19 11:15:31

@_dim 

 

Please note that R480T+ uses VLAN to isolate WAN and LAN. So the WAN port and LAN port cannot belong to the same VLAN. So in your topology, you cannot make port1 and port5 of R480T+ belong to VLAN20 at the same time.

Actually I don't know why you want to make local computer connect to WAN port. Maybe you can tell the reason then we can find other function to meet your requirement.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Interface configuration on R480T+-Solution
2020-05-07 02:40:43 - last edited 2021-04-19 11:15:31

@_dim 

 

Please note that R480T+ uses VLAN to isolate WAN and LAN. So the WAN port and LAN port cannot belong to the same VLAN. So in your topology, you cannot make port1 and port5 of R480T+ belong to VLAN20 at the same time.

Actually I don't know why you want to make local computer connect to WAN port. Maybe you can tell the reason then we can find other function to meet your requirement.

Recommended Solution
  0  
  0  
#2
Options