Not getting expected speeds

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Not getting expected speeds

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Not getting expected speeds
Not getting expected speeds
2020-05-28 11:24:52 - last edited 2021-04-19 11:06:04
Model: TL-R600VPN  
Hardware Version: V4
Firmware Version: 4.0.4 Build 20200313 Rel.41831

I'm having trouble getting expected speeds.

 

Configuration:

WAN1 = 1000Mbps/50Mbps cable connection

WAN2 = 40Mbps/3Mbps DSL connection

 

Both lines have been tested to provide expected speeds when connected directly or through a Netgear R7000 router. When I remove the Netgear from the equation and connect everything to the TL-R600VPN, my speeds burst to 400Mbps but come down to about 200Mbps.

 

Port status is showing all connections with a 1000Mbps full-duplex link.

 

Transmission --> Load Balancing

Load balancing is enabled.

Enable Application Optimized Routing is enabled.

 

Transmission --> Load Balancing --> Link Backup

Not configured.

 

Transmission --> Routing --> Policy Routing

One IP range configured to use WAN2 for lower bandwidth traffic.

Other IP range configured to use WAN1 for higher bandwidth traffic.

 

Am I missing a configuration somewhere or do I have something improperly configured?

 

  0      
  0      
#1
Options
1 Reply
Re:Not getting expected speeds
2020-06-12 02:47:02 - last edited 2021-04-19 11:06:04

@jaryd 

 

You can try to disable Application Optimized Routing.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 654

Replies: 1