IPsec VPN Connection With Dual WAN Link Backup Using TL-R600VPN?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IPsec VPN Connection With Dual WAN Link Backup Using TL-R600VPN?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
IPsec VPN Connection With Dual WAN Link Backup Using TL-R600VPN?
IPsec VPN Connection With Dual WAN Link Backup Using TL-R600VPN?
2020-06-11 12:50:18 - last edited 2021-04-19 11:06:26
Model: TL-R600VPN  
Hardware Version: V4
Firmware Version: 4.0.4 Build 20200313 Rel.41831

  When setting up an IPsec Lan-To-Lan VPN policy, I see that I need to specify a WAN port. Is there a way to setup the TL-R600VPN so the VPN connection is reestablished on the backup WAN  when the primary WAN is down?

 

  If it matters, site A has two ISPs and can be setup to be the Initiator of the tunnel and site B has one ISP (at the moment) and maybe have its VPN policy configured with 0.0.0.0 as the remote host. Both sites would have Dead Peer Detection setup and I assume Site B would detect the connection as down and delete the IPsec SA while site A would reestablish the tunnel under the backup WAN / IP address.

 

  Thanks.

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 540

Replies: 0