EAP225 SLOW UPLOAD SPEED

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP225 SLOW UPLOAD SPEED

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225 SLOW UPLOAD SPEED
EAP225 SLOW UPLOAD SPEED
2020-06-12 15:18:20
Model: AP200  
Hardware Version: V3
Firmware Version: 2.7

Hello

We have deployed COMADA EAP 225 Wireless AP
The Aps are connected to the sophos firewall in lan 
and Internet is terminated in to firewall, The internet is 50 MBPS
we are getting Good speed on wired as well as wireless 

however we are getting only 1 mbps of upload speed

if we check the wired upload speed it is 50 mbps, but we are getting 1 MBPS on wireless 

There are 6 APS in the area of 4000 Sqft,
the APS are well sepoarated from each other
please guide !

thanks

sachin-

  0      
  0      
#1
Options
1 Reply
Re:EAP225 SLOW UPLOAD SPEED
2020-06-12 19:47:08

Hi @BITSNBYTES,

 

Is this a wareheouse?  Or similar one big room?  Or do you have separate offices?  How many simultaneous users are you expecting?

 

6 AP's in 4000 sq feet seems like a lot -- unless the space is broken up with concrete / plaster walls.  Due you have the transmit power turned down to medium or lower?  Are you alternating channels (honeycomb) and using a narrow BW e.g. 20MHz?

 

Are you using all Cat5e or better?  All runs less than 100meters?  Midspan injectors or PoE?  AP's are ceiling mounted, facing down?

 

Do you have separate SSID's for 2.4G and 5.8G?  Either should eaisly be able to do 50Mbit.  My EAP225V3 does about 350-450 Mbit'/sec DL & UP on 5.8G w/80MHz BW -- Upload is actually faster usually.  But depending on your country and building layout you may not have too many channels to work with unless you narrow your BW.

 

If you stand under each EAP, one at a time, and let you're phone roam to to the local AP (or turn the all off, and turn on one at a time), do each give the same slow speeds?

 

There have been the occassional report here on the board of EAP's that seem like they may have a bad antenna / amplifier here or there -- though we've never confirmed this -- but it is highly unlikely all 6 would be bad.

 

Seems more like an interference or cabling related issue.

 

Are you using Omada server or OC-200?

 

-Jonathan

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1074

Replies: 1

Related Articles