TPLink Jetstream T2600G-52TS VLAN Problem

TPLink Jetstream T2600G-52TS VLAN Problem
TPLink Jetstream T2600G-52TS VLAN Problem
2020-06-25 02:56:16
Hardware Version: V3
Firmware Version: 3.0.0 Build 20180202 Rel.30718

Hi,

So we have a TPLink-Jetstream 48Port  Managed Switch and we setup VLAN20, VLAN30, VLAN40, VLAN50, VLAN60 for example in VLAN20 we setup the members 1/0/2 - 1/0/48 Untagged and 1/0/1 Untagged then saved then go to "Port Config" 1/0/2 PVID = 20 "Ingress Checking = Enabled", "Acceptable Frame Types = Admin All".

My VLAN1 is in default option with 1/0/1-1/0/48 Untagged Ports.

VLAN20 Network Address = 10.10.20.0/24

So from a PC I added a static IP addr, 10.10.20.5 and Gateway as 10.10.20.1

By the way, my TPLink Switch Port 1/0/1 is connected to an Unifi EdgeSwitch L3SW were my SVI(Switch Virtual Interface) configured.

I'm confused to about the VLAN tag and untagged. So if I want a port to only use VLAN 20 then I would setup that port tagged? and If 1 Port uses 2-3VLANs should I set it to Untagged Port?

 

 

 

0
0
#1
Options
1 Reply
Re:TPLink Jetstream T2600G-52TS VLAN Problem
2020-06-25 07:05:35

 

mariem56 wrote

So we have a TPLink-Jetstream 48Port  Managed Switch and we setup VLAN20, VLAN30, VLAN40, VLAN50, VLAN60 for example in VLAN20 we setup the members 1/0/2 - 1/0/48 Untagged and 1/0/1 Untagged then saved then go to "Port Config" 1/0/2 PVID = 20 "Ingress Checking = Enabled", "Acceptable Frame Types = Admin All".

 

So you have 5 networks (20, 30, 40, 50, 60). What is their purpose if all 48 ports are assigned to just one of those networks?

 

My VLAN1 is in default option with 1/0/1-1/0/48 Untagged Ports. 

 

 

This is a 6th network, to which all 48 ports are assigned to. What is the purpose of this network?

 

What are you trying to achieve with 48 access ports assigned to two networks?

 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
0
0
#2
Options