TL-SG108E Bandwidth control - can't set upload

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG108E Bandwidth control - can't set upload

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG108E Bandwidth control - can't set upload
TL-SG108E Bandwidth control - can't set upload
2020-07-10 14:10:22 - last edited 2020-07-28 10:23:34
Model: TL-SG108E  
Hardware Version: V5
Firmware Version: 1.0.0

Hello,

 

just installed the TL-SG108E switch and Bandwidth control in QoS doesn't work for upload. How can I limit the upload speed? 

  0      
  0      
#1
Options
2 Reply
Re:TL-SG108E Bandwidth control - can't set upload
2020-09-27 17:09:27

@Bazim 

 

Same problem here.

Download limits work as expected.

Specifying an upload limit for a port has no effect.

 

TL-SG108E 5.0

1.0.0 Build 20191021 Rel.53360

  0  
  0  
#2
Options
Re:TL-SG108E Bandwidth control - can't set upload
2020-09-28 09:13:04

@shmakes 

 

Download limits work as expected.

Specifying an upload limit for a port has no effect.

 

What bandwidth are you trying to limit on upload speed?

 

The TL-SG108E is a Gigabit Easy Smart Switch, the bandwidth control is unable to be so accurate. Actually, the smaller the limit, the less accurate the chip will be. For your reference, the granularity of the speed limit on Smart/Managed Switches is 64kbps.

 

Besides, it's suggested to use Iperf to check the speed after you configure the bandwidth control.

How to use Iperf to test the speed of TP-Link switches

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1307

Replies: 2