Business Community > Controllers > How To Add Rogue ap
< Controllers

How To Add Rogue ap

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How To Add Rogue ap

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How To Add Rogue ap
How To Add Rogue ap
2020-07-29 07:17:57 - last edited 2020-07-31 14:10:45
Model: OC200  
Hardware Version: V4
Firmware Version: 1.7.0 Build 20200703 Rel.59609

how can i add this rogue ap to trusted ap

so i can add the AP (network Wireless Connection)

 

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:How To Add Rogue ap-Solution
2020-07-29 07:46:57 - last edited 2020-07-31 14:10:45

@Samones, you need to adopt the EAP in the usual way.

 

If an EAP will be shown as a Rogue AP in a wireless survey, it has been set up already by somebody. To be able to adopt it you need to reset it to factory defaults (or forget it in another controller if managed by others) unless it is already at factory defaults and listed as »Pending«.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
Recommended Solution
  1  
  1  
#2
Options
2 Reply
Re:How To Add Rogue ap-Solution
2020-07-29 07:46:57 - last edited 2020-07-31 14:10:45

@Samones, you need to adopt the EAP in the usual way.

 

If an EAP will be shown as a Rogue AP in a wireless survey, it has been set up already by somebody. To be able to adopt it you need to reset it to factory defaults (or forget it in another controller if managed by others) unless it is already at factory defaults and listed as »Pending«.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
Recommended Solution
  1  
  1  
#2
Options
Re:How To Add Rogue ap
2020-07-31 13:46:07

@R1D2  Thank you i already connected the other EAP225

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 622

Replies: 2

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.