Business Community > Pharos Wireless Bridges > CPE210. AP mode to Client. Strong signals, no access
< Pharos Wireless Bridges

CPE210. AP mode to Client. Strong signals, no access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE210. AP mode to Client. Strong signals, no access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE210. AP mode to Client. Strong signals, no access
CPE210. AP mode to Client. Strong signals, no access
2020-08-17 00:48:00 - last edited 2020-08-17 12:36:32
Model: CPE210  
Hardware Version:
Firmware Version:

I have two CPE210. One set in AP on the back of house pointing to my back barn with the other  incident mode on barn. Router is 192.168.1.1

AP set to 192.168.1.254 and client 192.168.1.253. I have great signal strength, all devices will connect but no internet access. Anyone know what I'm doing wrong? 

  0      
 
  0      
 
#1
Options
1 Reply
Re:CPE210. AP mode to Client. Strong signals, no access
2020-08-18 12:34:29

Dear @Etaff,

 

AP set to 192.168.1.254 and client 192.168.1.253. I have great signal strength, all devices will connect but no internet access. Anyone know what I'm doing wrong? 

 

What's the LED status on the CPE in Client mode? Are the wireless signal LEDs lit up on the CPE_Client?

When you hardwire a PC to the CPE_Client via ethernet cable, do you obtain correct IP addresses and get internet access on the PC?

 

Please try referring to the guide below to check the issue, write back with the steps you tried and results you get. Thank you in advance.

How can I set up the AP + Client topology successfully?

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 752

Replies: 1

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.