Forums

Stories

Knowledge Base

Business Community > Switches > Support for DHCP pool for 1024 IPs

< Switches

Support for DHCP pool for 1024 IPs

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Support for DHCP pool for 1024 IPs

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

sagar002100

LV2

2020-08-18 13:36:16 - last edited 2020-10-15 05:20:48

Posts: 24

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2020-06-06

Support for DHCP pool for 1024 IPs

2020-08-18 13:36:16 - last edited 2020-10-15 05:20:48

Model: TL-R600VPN

Hardware Version: V4

Firmware Version: 4.0.3 Build 20190227 Rel. 48206

Hello, I have installed and configured TL-R600VPN router at a site. Site is such that it may have numbers of vistior at a time. So I need to configure pool of 1024 IPs in DHCP settings. I have used 172.21.0.0/16 as my LAN subnet and my router LAN IP is 172.21.21.21/16. But when I tried to configure DHCP range from 172.21.7.1 to 172.21.10.255 (total 1024 IP), it gives me an error that I can not configure pool larger than 256 IPs. This product is business product and it does not support large DHCP range. Can someone pleae help me in this?

1 Accepted Solution

Fae

2020-08-18 15:41:34 - last edited 2020-10-15 05:20:48

Posts: 3375

Helpful: 1278

Solutions: 431

Stories: 0

Registered: 2020-06-30

Re:Support for DHCP pool for 1024 IPs-Solution

2020-08-18 15:41:34 - last edited 2020-10-15 05:20:48

Dear @sagar002100,

The TL-R600VPN can only assign 256 IPs as it's designed for small business network.

For 1024 IPs in DHCP pool, the TL-ER5120 V3/V4, TL-ER6120 V2/V3 can do this job.

Hope this information helps. Best regards.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

Recommended Solution

2 Reply

Fae

2020-08-18 15:41:34 - last edited 2020-10-15 05:20:48

Posts: 3375

Helpful: 1278

Solutions: 431

Stories: 0

Registered: 2020-06-30

Re:Support for DHCP pool for 1024 IPs-Solution

2020-08-18 15:41:34 - last edited 2020-10-15 05:20:48

Dear @sagar002100,

The TL-R600VPN can only assign 256 IPs as it's designed for small business network.

For 1024 IPs in DHCP pool, the TL-ER5120 V3/V4, TL-ER6120 V2/V3 can do this job.

Hope this information helps. Best regards.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

Information

Helpful: 0

Replies: 2

Support for DHCP pool for 1024 IPs

Support for DHCP pool for 1024 IPs

Information

Voters 0

Tags