Home

Forums

Stories

Knowledge Base

Business Community > Controllers > Omada controller - connect EAP110 via CPE510 on 1.5km distance

< Controllers

Omada controller - connect EAP110 via CPE510 on 1.5km distance

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada controller - connect EAP110 via CPE510 on 1.5km distance

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Raeggan

2020-10-11 06:43:27 - last edited 2020-10-12 01:30:28

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-06-28

Omada controller - connect EAP110 via CPE510 on 1.5km distance

2020-10-11 06:43:27 - last edited 2020-10-12 01:30:28

Model: EAP110-Outdoor

Hardware Version: V3

Firmware Version:

Hi all,

I'm currently using Omada controller SDN v4.1.5. and it's working really great. This really help us to get another source of income during this pandemic.

I'm planning to create another "root" node to extend my wifi business on another location (approximately 1.5km away from my house). I've attached my WiFi structure plan for your reference.

Is this possible?
If not, is there another solution to deploy this use case?

Thank you guys!

1 Accepted Solution

R1D2

LV6

2020-10-11 20:45:30 - last edited 2020-10-12 01:30:28

Posts: 4334

Helpful: 1047

Solutions: 173

Stories: 3

Registered: 2015-12-05

Re:Omada controller - connect EAP110 via CPE510 on 1.5km distance-Solution

2020-10-11 20:45:30 - last edited 2020-10-12 01:30:28

@Raeggan, yes, you could use two CPE510 to create a wireless bridge to an EAP110-Outdoor wired to the LAN port of the remote CPE510.

Use operation modes »AP« for one CPE and »Client« for the other (which one is AP and which one the client doesn't matter).

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻

Recommended Solution

1 Reply

R1D2

LV6

2020-10-11 20:45:30 - last edited 2020-10-12 01:30:28

Posts: 4334

Helpful: 1047

Solutions: 173

Stories: 3

Registered: 2015-12-05

Re:Omada controller - connect EAP110 via CPE510 on 1.5km distance-Solution

2020-10-11 20:45:30 - last edited 2020-10-12 01:30:28

@Raeggan, yes, you could use two CPE510 to create a wireless bridge to an EAP110-Outdoor wired to the LAN port of the remote CPE510.

Use operation modes »AP« for one CPE and »Client« for the other (which one is AP and which one the client doesn't matter).

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻

Omada controller - connect EAP110 via CPE510 on 1.5km distance

Omada controller - connect EAP110 via CPE510 on 1.5km distance

Information

Voters 0

Tags