Using the TL-ANT5830MD antenna with OC200 Omada Hardware Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-12-04 11:17:12

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-12-04

Using the TL-ANT5830MD antenna with OC200 Omada Hardware Controller

2020-12-04 11:17:12

Model: TL-ANT5830MD

Hardware Version: V1

Firmware Version:

It is possible to use the TL-ANT5830MD antenna with OC200 Omada Hardware Controller?

1 Reply

2020-12-09 06:03:21

Posts: 3636

Helpful: 1391

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:Using the TL-ANT5830MD antenna with OC200 Omada Hardware Controller

2020-12-09 06:03:21

It is possible to use the TL-ANT5830MD antenna with OC200 Omada Hardware Controller?

What do you want to achieve with that?

The Omada Controller provides a platform to manage and configure the Omada series products such as Omada EAP, switch and gateway.

While the TL-ANT5830MD antenna is just a high-gain directional antenna, which cannot be configured at all.

What's more, it cannot be managed/configured via the Omada Controller even if you use the antenna with the Pharos WBS510.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*